Sunport C6 III MWT Mono Half Cut Solar Cell Module Panel Array Eff. 20.9% 370w 375w 380w 385w 390w

Sunport C6 III MWT Mono Half-Cut Solar Cell Module Panel Array Eff. 20.9% 370w 375w 380w 385w 390w Solar Module Panel

The Sunport C6 III MWT Mono Half-Cut solar panels are advanced photovoltaic modules that utilize Metal Wrap Through (MWT) technology and a half-cut cell design to maximize energy production. Available in power outputs ranging from 370W to 390W, these panels offer efficient and reliable performance for various residential, commercial, and industrial applications.

The panels feature advanced anti-reflective glass and cell surface texturing, enhancing light absorption and increasing energy production, even in low-light conditions. This makes them highly efficient and productive, allowing for maximum energy generation throughout the day.

Specification

Product Paramenters

Max-Power(Pm) 365w 370w 375w 380w 385w Power Tolerance 0~+5 Max-Power Voltage(Vm) 34.9 35.1 35.3 35.5 35.7 Max-Power Current(lm) 10.46 10.54 10.62 10.70 10.78 Open-Circuit Voltage(Voc) 42.4 42.6 42.8 43.0 43.2 Short-Circuit Current(lsc) 11.09 11.16 11.23 11.30 11.35 Module Efficiency(qm) 20.7 21.0 21.2 21.5 21.8 Operating Temperature(°C) -40℃～+85℃ Maximum system voltage DC1500V(IEC) Maximum series fuse rating 15A Temperature coefficients of Pmax -0.36%/°C Temperature coefficients of Voc -0.28%/°C Temperature coefficients of Isc 0.06%/°C Nominal operating cell temperature(NOCT) 43±2°C

 

TECHNOLOGY COMPARISON

Compared with conventional module, MWT modules reduce 3% shaded area with no busbars. MWT module technology replaces string ribbon by conductive back sheet, abandoning strain, micro-crack and results power degradation, greatly improving stability and reliability.

— Structural Feature —

MWT

Positive and negative electrodes are both on the rear side of solar cell

Conventional

Positive and negative electrodes are located on opposite sides of the cell

— Cell Structure —

MWT

Busbar-free design exhibits higher power output by decreasing shading area up to 3 %

Conventional

Conventional design covers more cell surface from the main busbars, therefore the power output is limited

— Module Encapsulation —

Replace conventional soldering with conductive foil and 2D encapsulation structure

Conventional Cells connected by string ribbons